Radr System Using Arduino

In this project, we are going to design an Arduino radar project using an ultrasonic sensor for detection. An Arduino microcontroller makes electronics more disciplined. This Arduino radar project aims to achieve a radar system prototype based on an Arduino board that detects stationary and moving objects. The radar system has different

How to make the RADAR system using Arduino. This is my second project. Mar 25, 2022

In this project, we will use an Arduino Uno, a HC-SR04 ultrasonic sensor, and a servo motor to create a simple radar system that sweeps across a given area and measures distances at various points. The idea is to rotate the servo motor in increments, with the ultrasonic sensor attached, and measure the distance at each angle.

Creating a radar system is a fascinating project that brings together various electronic components to build a functional and visually engaging device. In this guide, we'll demonstrate how to use an Arduino Uno, a sonar sensor, a servo motor, and a TFT display to build your own radar system. Follow along to integrate these components and see

Radar System Process. The servo motor rotates the ultrasonic sensor sideways. The ultrasonic sensor then calculates the distances ahead. Then those distances are taken into the processing IDE through serial communication and displayed as a radar system. OK, let's do it step by step. The required components are given below.

This Is the circuit which I will be using to make Arduino radar system. Circuit Diagram for Arduino radar system Explanation. Micro Servo. Micro servo has three terminals 2 terminals are for positive and ground power supply while the remaining one will be for signal transfer, here in my case orange, red and brown are colors of wire.

Place the Arduino Uno on your workspace. Connect the Servo Motor VCC Red wire 5V on Arduino. GND BrownBlack wire GND on Arduino. Signal OrangeYellow wire Pin 9 on Arduino. Connect the Ultrasonic Sensor HC-SR04 VCC 5V on Arduino. GND GND on Arduino. TRIG Pin 10 on Arduino. ECHO Pin 11 on Arduino

The Arduino Radar Project is more of a visual project than it is a circuit implementation. Of course, I will be using different hardware like Arduino UNO, HC-SR04 Ultrasonic Sensor and a Servo Motor but the main aspect is the visual representation in the Processing Application. If you remember, I have already used the Processing Application in

Now connect all the wires using the diagram above Breadboard Connections Red Wire Connect the VIN pin on the Arduino to the positive rail on the breadboard. Black Wire Connect the GND pin on the Arduino to the negative rail ground on the breadboard. Servo Connections Blue Wire Connect pin 12 on the Arduino to the orange wire signal of

Ultrasonic Radar with Arduino. Detect any object that comes in the range of this radar with ultrasonic sensor and Arduino. Aug 12, 2021